SHNITPWR 24V 3A DC Power Supply Adapter AC 100V~240V to DC 24 Volt 3 Amp 72W Converter Transformer 5.5x2.5mm Plug for 5050 3528 LED Strip Light 3D Printer LED Driver CCTV Security System LCD Monitor

Works great and easy to install

Works as it should. Perfect replacement for my lost cord to my nail lamp. Great value

I bought this for my broken power supply in my TS100 soldering iron. It's light weight and works perfectly. Honestly like it better than the original because the ac cord fits tighter into the brick than on the original.

Works well for powering LEDs and Fans for 3D printer enclosure. power brick is a bit warmer than what I expected, pulling about 50% current load of the maximum supported, but no issues so far.

Whooo wee! Thank god for this, plugged it into my light and it was so bright! The only thing is that when it's on for a long period, the brick gets pretty warm. Some days when I'm tattooing I'm wondering if it's going to explode. If it ever does I'll let y'all know.

When plugging this in with the included power cord, nothing happened. No light on the adapter. I fiddled with it and found an identical power cord around the house with a sufficient amp rating, and the light came on.I plugged in my 24 volt 50 watt LED strip and they lit up fine at full power. When dimming the LED, the adapter makes a high pitched noise. This adapter was recommended for the light I purchased and fits the specifications.So it's going back. I may have lived with using my own power cord instead of the defective cheap cord included, but I can't live with this noise. Looking for a better option.

I did a bunch of bench tests before I started using it for my TS100 soldering iron. It delivers a stable 23.9-24.5V with 3A, no problem, barely gets warm. I even pushed it shortly to 4 Ampere, the Voltage remained stable at 23.9V, and it did not get hot. This is way better than expected, I experienced many aftermarket powersupplies that are out of spec or get hot.

Upon recieving this power supply, I first noticed that there is a connector included for tensioning wires without a solder or crimp connection. I did not end up using this, but it would be very nice for other projects.The voltage tested out perfect, and the current was enough to run a 24vdc light at 3 amps. I have not noticed the power supply getting warm or hot from power on to the light or on standby.The only slight negative i would have is that the main power connection from 120v likes to wiggle free a little bit too easily for my taste, but that's not nearly enough to take a star off since it's easily fixed.I'll definitely be buying more for my next DC light projects.