EEMB Lithium Polymer Battery 3.7V 1800mAh 103450 Lipo Rechargeable Battery Pack with 2 Wires JST 2.0mm Connector for Speaker and Wireless Device- Confirm Device & Connector Polarity Before Purchase

Used to replace the swollen battery in my headlamp. It was the right voltage and current but the positive and negative were reversed in the plug. They were easily changed to the correct positions and then it plugged right in and works great.

I've had no issues with the battery, works as intended. Check the battery polarity on your board though. If you are getting this for the RAK meshtastic, you will need to reverse the wires.

I bought this to replace a battery in an Ecoxgear speaker. They don't sell the battery anymore for this speaker so I pulled the battery out and found this one. I had to switch the black and red wires at the connector but it seems to work great. It takes a charge and seems to last for a decent period of time.

The EEMB battery came in perfect condition, looked very fresh and well made, it took a charge perfectly, I used a lab bench linear powersupply, set it to, 4.2 volts, limited it to 1 Amp of current and progressively over the course of charging the onboard protection module slowly tapered off the current as it should, it came with a 3.6 voltage charge and I topped it off to 4.2 volts, it worked perfectly. I'm using it to power a Retekess Pr-15 pocket radio, I do wish I ordered the 1000 mah version since it would've been smaller, but it's fine, ill be cutting out the battery compartment and fit the lipo battery inside, the chip inside there can handle 4.5 volts, so it should be fine. After I spray out the volume control, headphone jack and volume/power switch with deoxit d5 contact cleaner and lube, I'll also be recapping the radio "there are only two Electrolytic's inside, but they're junk, so they'll be replaced with Panasonic KS-A series ECE-A1AKS221 and ECE-A1AKS101 they'll be ordered from mouser electronics as you really can't trust ebay or amazon for good quality official parts like that, perhaps I'll also put a Visaton K 50 FL - 16 ohm 2" mylar 1w rms speaker also available at mouser inside there too. Looking at the frequency response which was very nice and generally having good experience with visatons woofers and subwoofers, tweeters and other full rage speakers in the past, I could only imagine how clear it would be. Would just have to expand the speaker hole. To charge this lilo from 5v USB power, I picked these up 10Gtek# 1A 5V 18650 Lithium Battery Type-c USB TP4056, Charging Board with Protection Charger Module, Pack of 3 https://www.amazon.com/dp/B09KRK4MJR?ref=ppx_yo2ov_dt_b_product_details&th=1 just clip off the crappy jst connector and solder the batteries wires where they have to go and you're good.

Working good, weekly use, installed on bt small speaker

It did not fit the item that I needed it for. It was too small and the places was not compatible

Had to replace my daughter's battery in her sound machine. This was perfect for just that. Fit and works great

was a great replacement for a dead battery in a wireless controller for my computer also allowed me to double the battery life over the original size