LED Dimmer Switch, Trailing Edge Dimmer Light Switch for LED/Halogen Lights, 1 Gang 2 Way 3-150 Watts, Brushed Steel

Was easy to install and works as expected, no issues at all!

This has replaced the old dimmer switches. Prior to changing to these the lights were flickering a lot. Bulbs were changed etc, then the thought was to change the switches- no more flickering now. They look fine.

Not particularly elegant, but works well, even with LED lights. Note that the electrics behind it are deeper than your standard switch, so you may need to get a deeper switch box.

At 1/3rd the price of similar item from most DIY stores, this is fantastic value for money. easily fits to a standard switch back box. easy to wire in. No issues with this items manufacture or delivery, definitely recommendedone note of caution, note on paper the cables positioning in your old switch before undoing them, I didn't and got interrupted after taking off the old switch and connected to the new one in wrong order, took another 2 attempts to get the correct sequence. if its a single light switch for one light, that might not matter, but where you have 2 different switches, you really need them wired the correct way round.

Works well with dimmable lightbulbs. No noise or flickering. Easy to fit

Switch is well packaged as if it was a much more expensive item. Easy to install and fits standard back boxes. Feels quality with very positive on / off action.

The switch/dimmer itself works fine, no complaints there. The face plate however is of very poor quality. It has 2 earthing connectors attached to the back, poorly soldered right next to where the fixing screws go. Since the whole face plate is metal, it doesn't matter which of the two you use. As I was screwing in the earthing wire to one of them, the solder broke off and it just came off the faceplate with barely any force applied. I thought that maybe it was just a one-off defect, so I tried the other one. Yet, the same thing happened again with the other one. In the end I had to solder one of them back to the faceplate myself and this time it didn't come off. Eventually, I had it all installed but then I realised that the faceplate got some very fine scratches just by handing and installing it, even though I had been extra careful not to scratch it. Very poor quality indeed.

Looks ok but the switch was loose and needed tightening up before I could fit it.Replacing a dimmer switch that had gone faulty but this switch is much deeper than the one I took off so I've had to order a spacer plate to fill the gap.Check before buying.